Scantech V-1020 Manual do Utilizador descarregar pdf (Página 15)

1.6 USB INTERFACE

As like all USB devices, before connecting the VEGA with

USB interface to your host system, the connect driver

must be installed correctly on your host system for VEGA

operate successful.

Please contact Scantech-ID Technical Support Department

if you need the VEGA USB driver or this USB driver can be

downloaded from the web site:

www.scantech-id.com/support/downloads

1.7 CONFIGURING

How to configure the VEGA:

The Barcode Programming Feature gives the possibility to

change the VEGA scanner settings with use programming

codes or with the Utility Tool.

1.7.1 Changing Scanner Settings with Programming Codes

You can set-up your VEGA by scan all necessary

programming codes for parameters that meet applications.

After these scans the VEGA is direct permanently saved.

To go back to the factory default settings, just scan

only programming code factory default.

In order to change the scanner settings please follow the

sequence below:

(a) Power-up the scanner.

(b) Change scanner settings by scanning any of the

programming code that meet applications.

At any moment you can stop your programming, and if

needed read programming code factory default setting for

set your scanner back to default.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 50 51

Sem comentários

Scantech V-1020 Manual do Utilizador Página 15